Sand Blasting Room for Large Metal Surface Cleaning

Products detai:

1) Doors:

The service door is built in welded profiles and has a closing in steel plates,
and is internally coated with abrasion resistant rubber. An exclusive sealing
system prevents the loss of abrasive materials and makes the closing of the
doors possible, without effort. Optionally, two doors can be supplied (tunnel
type room) and one door for the operator. Sensors connected to the doors
automatically interrupt the blasting operation when one of them is opened.
2) Luminaries:
Each LED lamps construction and positioning enable maximum utilization of the
luminosity. The fastening system allows easy removal, for maintenance.
3) Working chambers:

Built in color steel tile, they are modulated in order to satisfy any
dimension in height, width and length. Inside (except on the ceiling) there is
a rubber coating that protects them against abrasion and helps in the acoustic
insulation.
4) Horizontal transportation of abrasive material:
This system combines the drive of scraper carts that conduct the abrasive
material to the center of the working chamber, where it is collected by a screw
conveyor (in some cases by a belt conveyor) which conducts the abrasive
material up to the foot of the bucket elevator (abrasive materials purifier).
On the whole floor surface, there is a grid that is covered with a perforated
plate, which retains larger impurities or even small parts which may drop
accidentally on the floor. This unique system used by CMV requires a much
smaller installed power that the other systems,

Minimum Order: 1 sets

Click to Enlarge