Horizontal Thermal Test Chamber

Application 
JOEO horizontal thermal test chamber is the best choice for batch testing and
large test loads. The interior design is used for custom environmental stress
screening of components and board level electronic components. The carrier
basket transfers loads between hot and cold zones in two - or three-zone
configurations, and is widely used in automotive, electronic and electrical,
aerospace, communication equipment, medical equipment and other industries.
Feature

The reference test load of the JOEO thermal test chamber is composed of 12
steel plates. Each pound of steel has an exposed surface area of 65 square
inches. The test load is oriented in the product carrier, with the airflow
parallel to the steel plate. The load is distributed between two product
carriers.If you need more models about our test equipment, please reference our
chamber-testing（.）com
The weight of any additional racks must be included in the test load shown
above.
The capacity depends on the stability of the product at extreme temperatures
before transfer. Do not use environment dwell time.
When assisted by liquid nitrogen, smaller mechanical refrigeration systems will
maintain low temperatures. Liquid nitrogen is required to meet the recovery
time.
For a liquid nitrogen only thermal chambers, the maximum load is liquid
nitrogen cooling without mechanical cooling.
Use IC chip product loading to recover 9 point products in 15 minutes or less.
The load is distributed between two product carriers.

Minimum Order: 1 pieces

Click to Enlarge