Dustproof Testing Machine for IP5X and IP6X

SC-015 Dust-proof Test Chamber (Sand Dust Chamber) is applied to physical and
other related performance tests for electronic and electrical products, lamps,
electrical cabinets, electrical components, automobiles, motorcycles and their
parts and other products under simulated dust climate conditions. After the
measurement, it is judged whether the performance of the product meets the
requirements through verification, so as to facilitate the design, improvement,
verification and factory inspection of the product. Comply meets IEC60529:1989
+A1:1999 +A2: 2013 ,IEC60598-1, GB2423.37-89 (Test L: dust test methods), GB4208, GB/T
4942.2-93(protective casing grade of low-voltage apparatus), GB7000.1
9.2.1, 9.2.2 and Figure 6,
DIN40050 and IP5K0. The dust test chamber is applicable to the IP5X and IP6X
dustproof test of the products.

Specifications:
• Temperature range: RT+10~50ºC
• Standard wire warp of metal net: 50um; Standard spacing between wires: 75um
• Test dust: dry talc powder; Talc powder dosage: 2~4kg/m; Dust reduction
method: free dust reduction
• Total test time: 0~999H (adjustable); vibration time: 0~999H (adjustable);
timing accuracy: ±1 second
• Vacuum: 0~10Kpa (adjustable); Pumping speed: 0~4800L/H (adjustable)
• Power supply of test samples: single-phase 220V/50Hz or 100V/60Hz
• Safety protection function: leakage protection, short circuit protection
• The shell is made of domestic high-quality steel plate, and the surface is
sprayed with paint, which is beautiful and durable.
• The inner box, sample rack, etc. are made of stainless steel plates to ensure
that they will not rust for a long time.
• There is a transparent observation window (toughened glass material) on the
door, and an LED lighting lamp is installed in the box to facilitate the
observation of the internal test situation.
• There is a device for replacing dust at the bottom of the device, which can
easily 100% replace the used dust.
• A special device is installed to ensure that the dust does not stick to the
wall and condense. The working time of the device is adjustable, and it can
work automatically and alternately.
• There is a suction pipe in the box, which can complete the vacuum action on
the sample (require the sample to reserve the suction hole position).
• Dust chamber testing control system: 7-inch touch screen + Panasonic PLC. The
dust blower, dust vibration and total test time can be controlled separately.
This controller has the following various arbitrary setting control functions:
1. Dust blowing time (stop, blowing): can arbitrarily choose any of continuous
and periodic dust blowing time to setting;
2. Vibration time: vibration and stop vibration time are automatically
alternated;
3. Preset test time: the maximum test time is 99 hours and 59 minutes;
• Heating system: The circulating air duct is equipped with a heater to heat
the dust to avoid dust condensation. The heat of the muffler mica sheet heating
ring is safe and stable.
• Vacuum system: equipped with vacuum pump, vacuum pressure, air filtration,
flow meter, pressure regulating triplet, connecting pipe.

Minimum Order: 1 sets

Click to Enlarge