CRP Rapid Test Cassette Diagnostic Blood Tests Rapid Chromatographic Immuno

A rapid test for the diagnosis of inflammatory condition by detecting CRP
qualitatively in whole blood, serum or plasma CE certified





Applications:



The CRP Rapid Test Cassette (Whole Blood/Serum/Plasma) is a rapid
chromatographic immunoassay for the qualitative detection of human CRP in whole
blood, serum or plasma as an aid in the diagnosis of inflammatory condition.
The cut-off of the test is 10 μg/ml.




Description:



C-reactive Protein (CrP) in patient’s sera has been found in association with
acute infections, necrotic conditions and a variety of inflammatory disorders.
There is a strong correlation between serum levels of CrP and the onset of the
inflammatory process. Monitoring the levels of CrP in patient’s sera indicates
the effectiveness of treatment and the assessment of patient recovery. It is
used in particular to differentiate bacterial infections from virus infections.





How to use?



Bring tests, specimens, buffer, and/or controls to room temperature (15-30°C)
before use.
1. Remove the Test Cassette from its sealed pouch, and place it on a clean,
level surface. For best results, the assay should be performed within one hour.
2. Open the tube with the diluted sample .Transfer 3 drops(approximately
120µL)of mixed specimens to sample well. Start the timer.
3. Wait for the colored lines to appear. The result should be read at 5
minutes. Do not interpret the result at 10 minutes.

CRP Rapid Test Cassette Diagnostic Blood Tests Rapid Chromatographic
Immunoassay 0




INTERPRETATION OF RESULTS



(Please refer to the illustration above)

POSITIVE:* Two lines appear. One colored line should be in the control line
region (C) and another apparent colored line should be in the test line region
(T).
*NOTE: The intensity of the color in the test line region (T) will vary
depending on the concentration of CRP antigen present in the specimen.
Therefore, any shade of color in the test line region (T) should be considered
positive.

NEGATIVE: One colored line appears in the control line region (C). No line
appears in the test line region (T).

INVALID: Control line fails to appear. Insufficient specimen volume or
incorrect procedural techniques are the most likely reasons for control line
failure. Review the procedure and repeat the test with a new test. If the
problem persists, discontinue using the test kit immediately and contact your
local distributor.

NOTE:
1. The intensity of the color in the test region (T) may vary depending on the
concentration of analytes present in the specimen. Therefore, any shade of
color in the test region should be considered positive. Please note that this
is a qualitatively test only, and cannot determine the concentration of
analytes in the specimen.
2. Insufficient specimen volume, incorrect operating procedure or expired tests
are the most likely reasons for control line failure.

Click to Enlarge