Air Pressure Switch Boiler Sensor 5mA 5VDC

C5 Air Pressure Switch Boiler Sensor Function
The gas water heater’s air pressure switch (which is actually the air pressure
sensor), usually located in the upper right corner of the water heater, is a
disc-shaped object about the size of a teacup lid, connected by three wires,
and a hollow plastic tube.

The air pressure sensor works roughly like this
The water-gas linkage device of the gas water heater is started by the water
flow after the hot water bridle is opened. The physical displacement drives the
micro switch, opens the solenoid valve to supply gas, and triggers the ignition
circuit.

At the same time, the micro switch also starts the strong exhaust fan, which
starts the forced exhaust system, the strong exhaust fan has a bypass, through
a small plastic pipe, to provide air pressure to the wind pressure sensor, the
wind pressure sensor built-in film, one side is subject to wind pressure (air
pressure), the sensor signal is continuously and stably provided to the
ignition control loop, once the sensor signal is interrupted, The machine logic
automatically cuts off the ignition circuit and closes the air valve.
Eventually, it will cause the water heater to passively stop working.

Air Pressure Switch Boiler Sensor 5mA 5VDC (1116)

Please the link to learn about other sensor-related products

Main parameters of the Air Pressure Switch Boiler
(1) Linearity: Air Pressure Switch Boiler refers to the degree to which the
actual relation curve between sensor output and input deviates from the fitting
line. Defined as the ratio of the maximum deviation between the actual
characteristic curve and the fitted line in the full-scale range to the output
value of the full scale.

(2) Sensitivity: Sensitivity is an important indicator of the static
characteristics of the sensor. It is defined as the ratio of an increment in an
output quantity to the corresponding increment in an input quantity that causes
the increment. The sensitivity is indicated by S.

(3) Hysteresis: When the input quantity of the sensor changes from small to
large (positive stroke) and the input quantity changes from large to small
(reverse stroke), the input-output characteristic curve does not coincide,
which becomes hysteresis. For the same size of the input signal, the positive
and negative stroke of the sensor output signal size is not equal, this
difference is called the hysteresis value.

(4) Repeatability: Repeatability refers to the degree of inconsistency of the
characteristic curve obtained when the input of the sensor changes continuously
in the full range in the same direction.

(5) Drift: the drift of the sensor refers to the output of the sensor changes
with time when the input is unchanged, and the second phenomenon is called
drift. There are two reasons for the drift: one is the structural parameters of
the sensor itself; Second, the surrounding environment (such as temperature,
humidity, etc.).

C5 Air Pressure Switch Boiler Specification
Model Number C5 without wire & connector
Working Medium Air or Gas tail gas
Withstand Pressure 2000Pa Max. (Pa to Psi)
Sensor Accuracy ±2%(Hz)
Dielectric Strength 500VAC (<3mA)
Rated Voltage DC4.75V – DC5.25V
Rated Current 5mA
Low-Duty-Cycle 50%
Working Temperature 40T90 (-40 to 90℃)

Minimum Order: 10 pieces

Click to Enlarge