20A AC Current Clamp GFUVE Q8A1 8mm Split Core CT Transformer Probe sensor

The model Q8A1 current probe/clamp on ct is based on AC transformer technology for
use in measurement of AC current, it is suitable for 5A, 10A cable online
measurement. With measurement range of 1 mA to 10A AC and frequency range from
40Hz to 200KHz, it has a high accuracy class of 0.1%. It suits for oscilloscope,
power quality analyzer, electric energy meter calibrator. Easy to operate
everywhere. its technical standard according to EN 61010-1, EN 61010-2-032,
IEC60044-1. This model Q8A1 clamp on current probe have been used in many
instrument manufacturers.

Electrical parameters
Ratio: 1000: 1, 2000:1 or 2500:1 (customized)
Accuracy class: 0.1 %,0.2%
Primary current: 0 - 5A AC, 0 - 10A AC, 0 - 20A AC
Secondary current: 0 - 2.5mA, 0-5mA, 0-10mA, 0-20mA AC (customized)
Secondary voltage: 0 - 50mV, 0-100mV, 0-200mV, 0-1V, 0-5V AC (customized)
Max. Cont. Input current: 24A
Load capacity: ≤20Ω , Standard 4Ω
Over voltage category: CAT III 600V
Output signal (AC current): From 0 to 10mA AC at nominal input current
Output signal (AC voltage): From 0 to 100mV AC at nominal input current
Signal ratio: 1mA/A, 1mV/A, 10mV/A, 100mV/A
Frequency range: 10Hz-200KHz
Dielectric strength: 3KV 50Hz/60Hz at 1minute
Temperature range: -20°C to +55°C
Output: 2.5 meter cable with D01 connector
Max. voltage not insulated conductors: 720 V
Standard: EN 61010-1, EN 61010-2-032, EN 61010-2-031
IEC60044-1, & IEC61869-2, 600V CAT III
Installation: Clamp type
Output mode: Lead output (2.5m)
Connector: BNC, 4mm banana, Audio plug,customized

Mechanical parameters
Dimensions (L x W x H) (mm): 42.6x122.5x23
Weight (g): 250
Holding wire diameter (mm): φ8
Max. jaw opening (mm): 8
Jaw color: Black
Material: PC+ABS+Polycarbonate, UL94 V0

Minimum Order: 3 pieces

Click to Enlarge