1mA-300A 2MHz Oscilloscope AC Clamp on Current probe S120 GFUVE 0.1 class

The S120 current clamp is a high performance AC Clamp on current transformer probe
with excellent transformation and low phase shift. The high quality magnetic
permalloy core and uniform windings provide for accurate measurements up to
3000AAC/2000AAC/1000AAC/500AAC. The "ring type" jaw permits good magnetic
conduction and cable positionings. Provide excellent RMS capabilities and reliable
signal reproduction.
The S120 clamp on ct is well suited for power quality applications where high
accuracy and low phase shift along with wide frequency from 10Hz to 2MHz are
important. Measurement range is 100mA to 3000A.
The S120 clamp on current transformer is a general purpose 3000A AC Clamp current
probe transformer designed for use with DMMs & BNC, cable fault analysis and
loggers instruments that have a current input. It has a 1000:1 or 2000:1 ratio and
output of 1mA per amp or 1mV per amp measured in the jaw. The S120 has an integral
2.5m or 5m lead terminated. The rounded jaw design on this clamp probe makes it
well-suited for cable fault analysis applications where high accuracy and low
phase shift and wide frequency.

Electrical parameters
Ratio: 1000: 1, 2000:5 or 3000:5(customized)
Accuracy class: 0.1%, 0.2%, 0.5%
Primary current: 0 - 3000A AC
Secondary current: 0-1A or 0 - 5A AC (customized)
Secondary voltage: 0-2V , 0-5V AC (customized)
Max. Cont. Input current: 3600A
Load capacity: ≤20Ω, standard 4Ω
Over voltage category: CAT III 600V
Output signal (AC current): 500mA, 1A,2A,5A AC at nominal input current
Output signal (AC voltage): 1V, 2V, 5V, 10V AC at nominal input current
Frequency range: 10Hz-2MHz
Dielectric strength: 3KV 50Hz/60Hz at 1 minute
Temperature range: -40°C to +55°C
Output: 2.5 meter cable with D01 connector or BNC
Max. voltage not insulated conductors: 600 V
Standard: EN 61010-1, EN 61010-2-032, EN 61010-2-031
IEC60044-1, & IEC61869-2, 600V CAT III
Installation: clamp type
Output mode: lead output(2.5m, 5m or 10m)
Connector: BNC, 4mm banana, signal cable(2 cores),customized
Range version: 100A, 200A, 400A, 500A, 1000A, 2000A, 3000A

Accuracy (3000A Range)
0-10A: ≤0.5%
10-100: ≤0.2%
100-3000A: ≤0.1%

Phase Shift(3000A Range)
0-10A: ≤0.5°
10-100: ≤0.2°
100-3000A: ≤0.1°

Mechanical parameters
Dimensions (L x W x H) (mm): 178 x 290 x 30
Weight (g): 1200
Holding wire diameter (mm): φ120
Max. jaw opening (mm): 120
Jaw color: Red & Grey
Material: PC+ABS, UL94 V0

Minimum Order: 3 pieces

Click to Enlarge